|
LarsBornholm
Denmark
1 Posts |
 Posted - 05/05/2021 : 11:16:05
|
Hello.
I would like to update my version 2.00 on GMC-600+
I tried to write directly to a mail I found on this site with no luck. I hope it could help on the problem described below:
My unit has been in my drawyer for a year. I works for 5 min, then I have to either restart or change the tube voltage (percentage)¨
It starts working at about 60% but then stops working after about 4-5 minutes.
GMC data viewer is at no use.
It gives bad readings in many ways.
I am a pure novice in this an just uses my unit in different locations for (comparison?) reasons
Is this understandable?
Regards
Lars |
|
How to update from rev. 2.00 and some malfunction
