GQ Electronics Technical Support Forum
.


GQ Electronics Technical Support Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
Password:
Save Password
Forgot your Password?

 All Forums
 GQ Electronics Forums
 3. GQ EMF EF Meter RF Spectrum Power Analyzer
 Wireless Weather Station Frequency
 New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

Bill D.

USA
44 Posts

Posted - 08/12/2020 :  05:54:23  Show Profile  Reply with Quote
I have a Davis wireless weather station that has frequency range from 918 MHz to 923 MHz (uses frequency hopping). In Vertical Mode, with the EMF 390v1 against the antenna, I can clearly pick up the transmission pulses every 3 seconds. The signal strength dwarfs all other signals. However, the 390 does not identify the frequency. Even in the table mode the frequency does not show up.

I am only able to see the frequency using the zoom feature in the RF Spectrum mode. When not zoomed out, the 923 MHz signal does not stand out even when the unit is touching the antenna.

Why can't I read the frequency in the vertical mode or table mode? The frequencies displayed are not even remotely close to the target frequency.


Edited by - Bill D. on 08/12/2020 05:57:14
Reply #1

EmfDev

1454 Posts

Posted - 08/12/2020 :  08:41:06  Show Profile  Reply with Quote
Hi Bill, it can be because the pulse is fast. It takes some time for the EMF390 to scan the other frequencies.
Go to Top of Page
Reply #2

Bill D.

USA
44 Posts

Posted - 08/14/2020 :  04:58:10  Show Profile  Reply with Quote
OK thanks. At least it detects it.
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
GQ Electronics Technical Support Forum © Copyright since 2011 Go To Top Of Page
Generated in 0.17 sec. Snitz's Forums 2000