GQ Electronics Technical Support Forum Active Users: / Visits Today:
Highest Active Users:
GQ Electronics Technical Support Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
 Password:
Save Password
Forgot your Password?

 All Forums
 GQ Electronics Forums
 3. GQ EMF EF Meter RF Spectrum Power Analyzer
 Differences in EMF Readings Between Modes		  New Topic  Reply to Topic
 Printer Friendly
Author Previous Topic Topic Next Topic  

Bill D.

USA
46 Posts
Posted - 06/28/2020 :  17:07:11  Show Profile  Reply with Quote
On the EMF-390, The EMF reading in the All-in-One mode does not equal the total of the EMF readings from each axis as displayed in the Table Mode or the EMF Graphs mode. The All-in-One mode shows a higher EMF than the combined total of all three axes.

Are we looking at a difference between a peak and three averages or is there another reason?
Reply #1

EmfDev

2250 Posts
Posted - 06/29/2020 :  09:03:56  Show Profile  Reply with Quote
The X Y Z total should be the dot product and not the sum of X Y and Z.
Go to Top of Page
Reply #2

Bill D.

USA
46 Posts
Posted - 06/29/2020 :  10:54:09  Show Profile  Reply with Quote
That makes sense since they are 3D vectors.
Go to Top of Page
  Previous Topic Topic Next Topic  
 New Topic  Reply to Topic
 Printer Friendly
Jump To:
GQ Electronics Technical Support Forum © Copyright since 2011 Go To Top Of Page
Generated in 0.05 sec. Snitz's Forums 2000