| Author |
 Topic  |
|
|
DanyO
Canada
1 Posts |
 Posted - 03/10/2013 : 10:14:54
|
Hi, I just received my new 5200 unit from MCUMall.
The hot air seems to be working well, but the temperature display for the Iron can only be described as "glitchy".
Example: I set the iron temp to 370C, turn off the unit for a few minutes. When I turn it back on, the display shows 503C, and will not change even if I play with the Iron temperature adjustments. However, if I slap the top of the unit, the temperature display will gradually come back down to 370C.
Example 2: Sometimes, if I set the temp adjustment to the lowest setting, and then I turn it up, the Iron temperature display will climb, but continually flash "503C" and come back to the real temperature.
Looks like there is a short, or bad solder joint somewhere. Have you ever seen this type of behavior? Is there anything I can do? |
|
| Reply #1
ZLM
1261 Posts |
Posted - 03/12/2013 : 10:59:32
|
It seems the temperture sensor has contacting problem.
Check the connector first. Make sure your iron connector is clean and well connected.
If it is not a problem, then you may need to check internal connector on PCB, reconnect it then. |
 |
|
| |
Topic |
|
|
|
5200 - Glitchy Iron Temp Display
