GQ Electronics Technical Support Forum Active Users: / Visits Today:
Highest Active Users:
GQ Electronics Technical Support Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
 Password:
Save Password
Forgot your Password?

 All Forums
 GQ Electronics Forums
 1.Geiger Counter World Map(www.GMCmap.com)
 Aiming my Yagi

Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!

Screensize:
UserName:
Password:
Format Mode:
Format: BoldItalicizedUnderlineStrikethrough Align LeftCenteredAlign Right Horizontal Rule Insert HyperlinkInsert EmailInsert Image Insert CodeInsert QuoteInsert List Spell Checker
   
Message:

* HTML is OFF
* Forum Code is ON
Smilies
Smile [:)] Big Smile [:D] Cool [8D] Blush [:I]
Tongue [:P] Evil [):] Wink [;)] Clown [:o)]
Black Eye [B)] Eight Ball [8] Frown [:(] Shy [8)]
Shocked [:0] Angry [:(!] Dead [xx(] Sleepy [|)]
Kisses [:X] Approve [^] Disapprove [V] Question [?]

   Insert an Image File
 Check here to include your profile signature.
    

T O P I C    R E V I E W
Dave Smith Posted - 09/18/2023 : 07:44:09

I plan to use the EMF-390 to aim a directional (Yagi) antenna at a single cell tower in rural Maine, USA.

The goal is to install an all-band cellular phone repeater in a remote cabin. Thanks to the on-line GQ tower map, I located 3 potential cell towers.

Now I need to determine which tower provides the best signal and then point the antenna to it. I need to learn:

1. A good way to setup the EMF-390 so I can see the change in cellular signal strength as I rotate my local antenna mast.

2. How to feed the incoming signal from the antenna down-lead (coax, with a male SMA connector) to the EMF-390. I am thinking of a small coil of wire taped to the EMF-390 and clipped to the center copper of the coax.

Any thoughts you may have will be appreciated.

Dave Smith

GQ Electronics Technical Support Forum © Copyright since 2011 Go To Top Of Page
Generated in 0.06 sec. Snitz's Forums 2000