GQ Electronics Technical Support Forum Active Users: / Visits Today:
Highest Active Users:
GQ Electronics Technical Support Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
 Password:
Save Password
Forgot your Password?

 All Forums
 GQ Electronics Forums
 4. GQ Hot Air Soldering Rework Station
 GQ-5200 Error code 1

Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!

Screensize:
UserName:
Password:
Format Mode:
Format: BoldItalicizedUnderlineStrikethrough Align LeftCenteredAlign Right Horizontal Rule Insert HyperlinkInsert EmailInsert Image Insert CodeInsert QuoteInsert List Spell Checker
   
Message:

* HTML is OFF
* Forum Code is ON
Smilies
Smile [:)] Big Smile [:D] Cool [8D] Blush [:I]
Tongue [:P] Evil [):] Wink [;)] Clown [:o)]
Black Eye [B)] Eight Ball [8] Frown [:(] Shy [8)]
Shocked [:0] Angry [:(!] Dead [xx(] Sleepy [|)]
Kisses [:X] Approve [^] Disapprove [V] Question [?]

   Insert an Image File
 Check here to include your profile signature.
    

T O P I C    R E V I E W
ZLM Posted - 12/03/2011 : 22:33:33
The Error 1 means the unit is unable to heat the hot air element.

It could be the element contacting bad or broken.

In this case you need to open the handle and check the hot element. To see if its connector open or element is broken.

If the element is broken, replace it with the backup element.

Once the new element installed, the starting temperature should be keep low for at least 10 minutes with a higher air volume, then turn the temperature little higher for another 10 minutes with a higher air volume.

This gradually increase temperature just let a new hot element be completely oxidized.

GQ Electronics Technical Support Forum © Copyright since 2011 Go To Top Of Page
Generated in 0.05 sec. Snitz's Forums 2000