GQ Electronics Technical Support Forum Active Users: / Visits Today:
Highest Active Users:
GQ Electronics Technical Support Forum
Home | Profile | Register | Active Topics | Members | Search | FAQ
Username:
 Password:
Save Password
Forgot your Password?

 All Forums
 GQ Electronics Forums
 4. GQ Hot Air Soldering Rework Station
 GQ5300 SOLDETING IRON TEMP CALIBRATION

Note: You must be registered in order to post a reply.
To register, click here. Registration is FREE!

Screensize:
UserName:
Password:
Format Mode:
Format: BoldItalicizedUnderlineStrikethrough Align LeftCenteredAlign Right Horizontal Rule Insert HyperlinkInsert EmailInsert Image Insert CodeInsert QuoteInsert List Spell Checker
   
Message:

* HTML is OFF
* Forum Code is ON
Smilies
Smile [:)] Big Smile [:D] Cool [8D] Blush [:I]
Tongue [:P] Evil [):] Wink [;)] Clown [:o)]
Black Eye [B)] Eight Ball [8] Frown [:(] Shy [8)]
Shocked [:0] Angry [:(!] Dead [xx(] Sleepy [|)]
Kisses [:X] Approve [^] Disapprove [V] Question [?]

   Insert an Image File
 Check here to include your profile signature.
    

T O P I C    R E V I E W
Musicrobert777 Posted - 06/28/2024 : 13:49:17
GQ5200 recalibration after replacing A1322 soldering iron heater core.
Iron is heating when set to 350c... But only comes up to 270c actual measured temperature.
Is there a calibration trim potentiometer.... Calibration process ???
Same thing when other known good irons are swapped in.

GQ Electronics Technical Support Forum © Copyright since 2011 Go To Top Of Page
Generated in 0.03 sec. Snitz's Forums 2000